HP L1695A Lamp Bulb Replacement for HP VP6325 Projector

Buy Cheap HP L1695A Projector Lamp,The HP L1695A Lamp Bulb Replacement for HP VP6310, VP6311, VP6315, VP6320, VP6321 and VP6325 Digital Projectors,The vp6325 projector’s 4000-hour lamp lasts longer than the lamps of most other projectors

Replacing the lamp module (HP L1695A)
As the projector operates over time, the brightness of the projector lamp gradually decreases and the lamp becomes more susceptible to breakage. You can install a new lamp at any time to bring the projector up to factory-fresh brightness. We recommend replacing the lamp if a warning message is displayed.

1. Turn off the projector and allow it to cool for 30 minutes.
2. Unplug the power cord.
3. Press the release latch 1 on the lamp cover and remove the cover 2.
4. Press the release latch on the lamp connector and unplug the connector 3.
   
   
5. Loosen the two screws 4 on the lamp module, and pull out the module 5.
   
6. Insert the new lamp module into the projector and tighten the two screws.
7. Plug in the lamp connector.
8. Snap the lamp cover into place.
9. Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling the lamp.
10. Press enter, go to Setup > Advanced setup > Reset lamp hours, and press enter.