Replacing the Lamp Epson PowerLite 1830 Projector (V13H010L53)

The Epson PowerLite 1830 Projector keeps track of the number of hours the lamp is used and displays this information in the projector’s menu system.
Replace the lamp as soon as possible when the following occurs:

• The projected image gets darker or starts to deteriorate
• A message appears when you turn on the projector telling you to replace the lamp
• The projector’s lamp light is flashing orange

Replacing the Lamp
Resetting the Lamp Timer

Replacing the Lamp Epson PowerLite 1830 Projector

Before you replace the lamp, let the projector cool down for at least one hour so the lamp will not be hot.
WARNING: Let the lamp fully cool before replacing it to avoid injury.
You can replace the lamp while the projector is mounted to the ceiling, if necessary.

1. Turn off the projector and unplug the power cord.
2. Allow the projector lamp to cool down for at least one hour.
3. Use the screwdriver

WARNING: If the lamp is broken, glass fragments may be loose inside the lamp chamber. Be careful removing any broken glass to avoid injury.
4. Slide the lamp cover out and lift it off.

5. Loosen the screws securing the lamp to projector. The screws do not come all the way out.

6. Grasp the lamp as shown and pull it out of the projector.

Note: The lamp in this product contain mercury. Please consult your state and local
regulations regarding disposal or recycling. Do not put in the trash.
7. Gently insert the new lamp into the projector. If it does not fit easily, make sure it is facing the right way.

CAUTION: Do not touch any glass on the lamp assembly to avoid premature lamp failure.

8. Push in the lamp firmly at the labelled point and tighten the screws to secure it.

9. Replace the lamp cover and tighten the screw to secure it.

Reset the lamp timer to zero to keep track of the new lamp’s usage.

Resetting the Lamp Timer
You must reset the lamp timer after replacing the projector’s lamp to clear the lamp replacement message and to keep track of lamp usage correctly.
Note: Do not reset the lamp timer if you have not replaced the lamp to avoid inaccurate lamp usage information.

1. Turn on the projector.
2. Press the Menu button.
3. Select the Reset menu.



4. Press Enter.
5. Select Reset Lamp Hours and press Enter.
You see a prompt asking if you want to reset the lamp hours.
6. Select Yes and press Enter.